Westerbeke 15.0KW -60Hz EDT Manual do Operador Página 38

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 100
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 37
Generator
Make
sure thet the AC output connections within the generator's distribution
box
are and in accord-
ance with the specific
AC
Load Connections diagram found later in this manual. (See the 'BT GENERATOR'
section
of
Ihis manual, page 56.)
Do not smoke or allow
an
open flame near batteries. Lead acid batteries emit hydregen, a
highly-explosive gas.
Balterles
Make sure the positive ( + ) battery connection is connected
to
the battery connection of the starting solenoid.
The negative
(-)
battery connection should be connected
to
the system ground (the engine block).
When servicing the battery
or
checking the electrolyte level, wear rubber gloves, a rubber
apron, and eye protection. Battery acid may splash on the skin
or
into the eyes inadvertent-
ly when removing the electrolyte caps.
Check the battery's electrolyte level and specific gravity
to
ensure maximum engine starting efficiency. Make
sure the battery's
terminals are clean and tight.
Ventilation
The ventilation requirements
01
the generator sets include the following: combustion air is required
lor
the
engine cylinders;
cooling air
is
required
lor
the generator end and also
lor
removing the heat produced by
the generator's engine during operation; and ventilating air is required
to
clear the bilges below the gener-
ator, as well as the compartment in which the generator
is
located, of potentially toxic and lIammable diesel
fumes. Refer
to
the "SYSTEM SPECIFICATIONS" section
01
this manuai
for
the airflow requirements
01
the
generator sets, page
13
forthe
BTG
8.5KW,
page
17
forthe
BTG
12.5KW,
and page
21
forthe
BTG
15.0KW.
Weslerbeke Generators
34
Vista de página 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 99 100

Comentários a estes Manuais

Sem comentários