Westerbeke WPDS-20 Manual do Operador descarregar pdf (Página 48)

Engine

Oil

Change

(to

include

filter)

Draining the Oil Sump

Remove the oil drain hose from

attachment bracket

and lower the end

the hose into a container

allow

the oil

drain,

attach a pump

the drain hose and

pump the oil out. Make sure the oil drain hose

properly secured in its holder after all

the old oil has

been removed.

Always observe the old oil as

removed. A yel-

low/gray emulsion indicates the presence

water in

the

oil. Although this condition

rare, it does require

prompt attention

prevent serious damage. Call a

competent mechanic should water be present

the oil.

Sea water present

the oil can be the result of a fault

in the exhaust system attached

the engine and/or a

siphoning through the sea water cooling circuit into the

exhaust, filling

into the engine (refer

the instal-

lation illustrations on page 15).

Replacement

the Oil Filter

When removing the used oil filter, you may find it

helpful and cleaner

punch a hole in the upper

and lower portion of the old filter

drain the oil

from

It Into a container before removing it. This

helps

lessen spillage. A small style automotive

filter wrench should

helpful in removing the old

oil filter.

Place some paper towels and a plastic

bag around the filter when unscrewing it to catch

any oil left

the filter. (Oil

any other fluid on

the engine reduces the engine's cooling ability.

Please keep your engine clean.)

Inspect the old

oil filter as it is removed

make sure that the rub-

ber sealing gasket came off with the old oil filter.

this

rubber

sealing gasket remains sealed

against the engine block, gently remove it. The

replaceable cartridge-type oil filter requires no

cleaning inside, so it may be properly disposed of.

When Installing the new oil filter element, wipe the

I\IIIIIIIIII!

111\

ilill':

\;:I;P:!'

1.1",.

1 '

, : : !

Oil

Filter

(Part

Number

16655)

Oil Filter Bracket

Oil

Filter

filter gasket's sealing surface on the engine block free

oil and apply a thin coat

clean engine oil

the

rubber gasket on the oil filter.

Screw the filter onto the threaded oil filter stub, and then tighten the filter firm-

hand. See the "TORQUE SPECIFICATIONS" section

this manual for the proper oil filter tightening

specification, page

61.

Westerbeke Diesel

Engines

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 113 114

Comentários a estes Manuais

Sem comentários

Westerbeke WPDS-20 Manual do Operador Página 48

Comentários a estes Manuais

Manuais e produtos relacionados com Motor Westerbeke WPDS-20