Westerbeke 38B FOUR Manual do Operador Página 89

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 108
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 88
Valve Clearance
Adjustment
(W
38B FOUR and W 42B FOUR Engines)
CAUTION
Adjust the valve clearance when the
engine is cold.
Tighten the cylinder head bolts
to
the
specHied torque before adjusting the
valves. (See page 85.)
\.
TDC
MARK
Position
for
Cylinder.
No.1
and
4
1.
Pull off the air breather pipe from the rock-
er cover, and take off the rocker cover
bolts and the rocker cover.
\
~'"''
'
2.
Adjust the valve clearances
atTDC
(fop
TOC
MARK
~
~
Dead Center) for each cylinder when they
Po.
i t
ion
for
are on their compression stroke. Remem- C y 1 i n
d.
r s
berthe engine's firing order
is
1-3-4-2. The
No.2
and
3
engine's valves must be adjusted in this
order while the
valves are closed. You
may
find
that
turning
the
engine's
crankshaft
is
more easily accomplished
when
the
engine's
glow
plugs
are
removed before the crankshaft
is
rotated.
CRANKSHAFT
PULLEY
A.
Rotate the engine in the normal direction
of
rotation placing the
NO.1
cylinder at the
top
of
its compres-
sion stroke. The TDC mark on the crankshaft
pulley should be in line with the pointer on the front of the
gear case cover, and the
valves for the No.1 cylinder should be closed.
Now
adjust the intake and ex-
haust
valves for cylinder NO.1.
B.
After adjusting the valves for cylinder No.1, rotate the front crankshaft pulley clockwise 180" so the TDC
mark on the
pulley is positioned approximately in the position shown in the illustration shown above for
cylinder
No.3.
Now
adjust the intake and
exhaust
valves for cylinder NO.3.
C.
Rotate the crankshaft pulley clockwise
another
180" and adjust the valve clearances
for
the Intake and exhaust valves for cylinder
No.4.
D.
Rotate the crankshaft pulley clockwise
another 180" and adjust the valve clearances
for the intake and exhaust valves for cylinder
NO.2.
Adjust each valve's clearance
by
inserting a 0.010
inch (0.25 mm) feeler gauge between the rocker
arm and the
valve stem.
87
ADJUST
VALVES
TO
0.010
INCHES
(0.25
MMJ
Westerbeke Diesel Engines
Vista de página 88
1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 107 108

Comentários a estes Manuais

Sem comentários